8 Stored Programming
398
Stored Programming
8
Calling a Stored Program
The following describes how to call a stored program.
When you call a specified stored program, the last screen shown when you registered the
stored program appears.
1
Press the <Services Home> button.
2
Select [Stored Programming].
3
Select a number of a stored program
containing the features you want to use.
Note • You can only select registered numbers.
• After the stored program has been called, the machine sounds an audible tone. If a failure occurs,
the machine sounds a fault tone.
For information on how to change the volume of the sound that notifies that a stored program has been called, refer to "5
Tools" > "Common Service Settings" > "Audio Tones" > "Stored Programming Complete Tone" in the Administrator Guide.
4
After the stored program is called, select other features if necessary.
5
Press the <Start> button.
To Next Page
Loading...
Need help?
General
