6.8 Non-genuine Mode 127
6.8 Non-genuine Mode
When toner within a toner cartridge is empty, the [Replace XXX Crtrdg] (XXX: Yellow,
Magenta, Cyan, or Black) message appears.
When you want to use the printer in Non-genuine mode, use the following procedure to
program the mode and replace the toner cartridge.
Important
• If you use the printer in the Non-genuine mode, the performance of the printer may degrade. Any
problems that may arise from the use of the Non-genuine mode are not covered by our quality
guarantee. Continuous use of the Non-genuine mode can also cause the printer to break down, and any
repair charges for such break down will be borne by the owner.
Note
• To disable the Non-genuine mode, select [Off] in Step 4.
1. Press the < > and <Eject/Set> buttons
simultaneously on the control panel.
[Consumables Menu] is displayed.
2. Press the < > or <Eject/Set> button.
[Toner] is displayed.
3. Press the < > or <Eject/Set> button again.
The current setting is displayed.
4. Press the < > button to display [On].
Then, press the <Eject/Set> button to
confirm the selection.
5. Press the <Menu> button.
The printer switches to the Non-genuine
mode.
Consumables Menu
Non-genuine
Non-genuine
Toner
Toner
Off *
Toner
On *
Ready to Print
Non-genuineToner
To Next Page
Loading...
Need help?
General
