7.14 Moving the Printer 175
7.14 Moving the Printer
Carry out the following procedure when moving the printer.
Important
• This product weighs 18.2 Kg. When moving it, always carry it by a team of two or more persons to avoid
mishandling or injury.
• When lifting this product, firmly grip the recessed areas provided on both sides of the printer. Never lift it
by gripping any other areas. It will prevent you from dropping the product and getting back ache or
injuries.
• If the 250 Sheet Feeder (optional) has been installed, uninstall it before moving the printer. If these are
not fixed securely to the printer, they may fall to the ground and cause injuries. For details on how to
uninstall the optional accessories, refer to the each manual that came with each accessory.
• The front side of this printer is heavier than the rear. Take note of this difference in weight when moving
the printer.
1. Press the power switch of the printer to the
< { > position to turn off the power.
2. Disconnect the power cord, interface cable,
and any other cables.
Important
• Never touch the power cord with wet hands. It may
cause electric shock.
• Hold the plug not the cord when unplugging this
product, or it may damage the cord and cause electric
shock or a fire accident.
3. Remove any paper in the output tray and
slide the tray extension inside the printer.
To Next Page
Loading...
Need help?
General
