306 7 Maintenance
5. Insert the front side of the new staple case
into the staple cartridge (1), and then push
the rear side into the cartridge (2).
6. Push the staple cartridge into the finisher
until it clicks into place.
7. Close the front door.
Note
• If the front door is not completely closed, a message
will appear and the machine remain paused.
Replacement Procedure (for Booklet Maker Unit for Finisher-B1)
When the message Staple Cartridge R2 / R3 is displayed on the display, follow the
instruction below to replace the staple cartridge with a new one.
1. Make sure that the machine is not
operating, and open the booklet maker side
cover.
2. Hold the tabs on both sides of the staple
cartridge and pull the cartridge out of the
finisher.
To Next Page
Loading...
Need help?
General
