Fujitsu Oracle SPARC M12-2 User Manual

Table 4-19
Active/Cold Replacement Procedure of the PSUBP (continued)
Work
Order
Task Reference
15 Checking the operating condition of the
system and the I/O device usage status
"9.2 Checking the Operation Status and
Resource Usage Status of Oracle Solaris"
*1 This unit and the XSCFU cannot be replaced at the same time.
*2 If the replaced PSUBP was in a SPARC M12-2S with no PCIe cards mounted, no diagnosis is necessary
(because diagnosis was performed in the previous step).
Table 4-20
Active/Cold Replacement Procedure of a PCI Expansion Unit
Work
Order
Task Reference
1 Checking the operating condition of the
system and the I/O device usage status
"9.2 Checking the Operation Status and
Resource Usage Status of Oracle Solaris"
2 Checking the logical domain assignment
status of CPU resources mounted in the
SPARC M12-2S requiring maintenance
"3.2.4 Checking the Assignment Status
of Resources" in the Fujitsu
SPARC M12
and Fujitsu M10/SPARC M10 Domain
Configuration Guide
3 Checking the logical domain assignment
status of memory resources mounted in
the SPARC M12-2S requiring maintenance
"3.2.4 Checking the Assignment Status
of Resources" in the Fujitsu SPARC M12
and Fujitsu M10/SPARC M10 Domain
Configuration Guide
4 Releasing I/O resources of the SPARC
M12-2S requiring maintenance from a
logical domain
"9.3 Releasing I/O Resources From a
Logical Domain"
5 Releasing the SPARC M12-2S requiring
maintenance from the physical partition
"9.4.3
Dynamically Releasing the
SPARC M12-2S From the Physical
Partition"
6 Releasing the SPARC M12-2S requiring
maintenance from the building block
configuration
"9.6.1 Releasing the SPARC M12-2S
From the Building Block Configuration"
4.2.13 Active/Cold Replacement Workflow of the PCI
Expansion Unit
You can perform active/cold replacement of a PCI expansion unit in the following
configuration:
■
Configuration connecting two or more SPARC M12-2S units to a physical partition
Table 4-20 shows the workflow for active/cold replacement of a PCI expansion unit.
Table 4-20 describes the procedure for replacing a FRU while the power cords of the
PCI expansion unit are disconnected.
For replacement procedures for FRUs while the
power cords of the PCI expansion
unit are connected, see "7.1.1 Hot Replacement" in the PCI Expansion Unit for Fujitsu
SPARC M12 and Fujitsu M10/SPARC M10 Service Manual.
Chapter 4 FRU Replacement Workflows 93

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English