Fujitsu Oracle SPARC M12-2 User Manual

Note -
Unless otherwise noted, the model used in the figures shown in the following
procedures is the SPARC M12-2S.
Note -
When you add a PCIe card or perform maintenance in the inactive or system-stopped
state, this step is not necessary.
Note -
To release a PCIe card from an active system by using PCI Hot Plug or PPAR DR, you
need to make sure that the I/O resource of the PCIe card to be released or the I/O resource of
the SPARC M12-2S to be released is not assigned to a logical
domain. For details, see "9.3
Releasing I/O Resources From a Logical Domain" or "3.2 Operations and Commands
Related to Logical Domain Configurations" in the Fujitsu SPARC M12 and Fujitsu M10/
SPARC M10 Domain Configuration Guide.
12.3 Removing a PCIe Card
This section describes the procedure for removing a PCIe card.
12.3.1 Enabling the Removal of a PCIe Card
1.
Release the PCIe card from the system.
2.
Lower the cable support.
For details on handling the cable support, see "9.8.1 Lowering the Cable
Support."
Figure 12-3
Lowering the Cable Support
3.
Remove the cable connected to the PCIe card.
Chapter 12 Maintaining PCIe Cards 387

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English