Fujitsu Oracle SPARC M12-2 User Manual

Table 5-22
System-Stopped/Cold Addition Procedure of a PCIe Card
Work
Order
Task Reference
1 Powering off all physical partitions "9.5.2 Stopping All Physical Partitions"
2 Switching the mode switch on the OPNL
to Service
"2.3.2 OPNL Control Function"
3Removing the power cords of all the
SPARC M12-2/M12-2S units
"9.8.2 Removing the Power Cords"
5.6 System-Stopped/Cold Addition
Workflows
This section describes the workflows for system-stopped/cold addition of FRUs to the
SPARC M12-2/M12-2S, and the workflow for system-stopped/cold addition of a
SPARC M12-2S to another SPARC M12-2S.
The described procedures are performed after all the SPARC M12-2/M12-2S units are
placed in the cold state, without using the maintenance menu.
Note that,
in a building block configuration, you can perform maintenance using the
maintenance menu when only the SPARC M12-2S requiring maintenance is in the
cold state. For work procedures with the maintenance menu, see "5.4 Inactive/Cold
Addition Workflows."
Before performing addition work, be sure to check the notes on maintenance work
in
the Fujitsu SPARC M12 Product Notes of the XCP version used.
Each of the following sections puts together the order of work and the tasks for each
FRU into a table. For details on each task, see the reference shown in the table.
The following FRUs are subject to system-stopped/cold
addition:
■
PCIe card
■
HDD/SSD
■
CMUU
■
Memory
■
PCI expansion unit
■
SPARC M12-2S
5.6.1 System-Stopped/Cold Addition Workflow of a PCIe
Card
Before adding the PCIe card, see "Precautions for PCIe card addition" in "7.2
Precautions for FRU Expansion."
Table 5-22 shows the workflow for system-stopped/cold addition of a PCIe card.
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023180

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English