Fujitsu Oracle SPARC M12-2 User Manual

Table 5-18
Inactive/Cold Addition Procedure of the SPARC M12-2S (continued)
Work
Order
Task Reference
7 Confirming that there is no problem with
the added SPARC M12-2S
"10.5.3 Checking the FRU Status After
Maintenance"
8 Configuring memory mirroring if
duplicating memory
"7.6 Configuring Memory Mirroring" in
the Fujitsu SPARC M12-2S Installation
Guide
9 Adding the added SPARC M12-2S to the
PPAR configuration list for the physical
partition that is the
incorporation
destination
"7.7 Creating a PPAR Configuration
List" in the Fujitsu SPARC M12-2S
Installation Guide
10 Assigning the SPARC M12-2S (system
board) to the physical partition
"7.8.1 Assigning a Physical System
Board (PSB) to a Physical Partition
(PPAR)" in the Fujitsu SPARC M12-2S
Installation Guide
11 Switching the mode switch on the OPNL
to
Locked
"2.3.2 OPNL Control Function"
12 Powering on the physical partition of the
added SPARC M12-2S
"10.9.1 Starting the System With an
XSCF Command"
13 Assigning the resources of the added
SPARC M12-2S to logical domains
"3.2 Operations and Commands Related
to Logical Domain Configurations" in the
Fujitsu SPARC M12 and Fujitsu
M10/SPARC
M10 Domain Configuration
Guide
*1 Connect cables by following the workflow of the addfru command.
5.5 System-Stopped/Hot Addition
Workflows
This section describes the workflows for system-stopped/hot addition of FRUs to the
SPARC M12-2/M12-2S.
Before performing addition work, be sure to check the notes on maintenance work in
the Fujitsu SPARC M12 Product Notes of the XCP version used.
Each of the following sections puts together the order of work and the
tasks for each
FRU into a table. For details on each task, see the reference shown in the table.
The following FRUs are subject to system-stopped/hot addition:
■
PCIe card
■
HDD/SSD
■
PCI expansion unit
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023176

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English