6. WEB FUNCTIONS
6-9
6.1.7 How to set internal call routing
When a voice call (only 4kbps AMBE+2) is received, the call can be transferred to an
internal phone automatically. Follow the procedures to set up the internal call routing.
1. Click [Settings] in the menu bar.
2. Click [PBX settings].
3. Click [Advanced settings].
4. Click [Internal call routing].
5. To enable the internal call routing function, put a checkmark in the Enable/Disable
box. With no checkmark this function is deactivated, and a call is routed according
to the setting of [PBX settings / Extension] in paragraph 6.1.3.
6. Select a guidance language; English or Japanese.
7. Set a timeout time between 10 seconds to 99 seconds.
8. Click the [Apply] button to activate the internal call routing. The message "Setting
Completed." appears.
9. Click the [OK] button to erase the message.
When a voice call is received, the FELCOM 250/500 plays guidance to the calling par-
ty. Then, the calling party inputs an extension number. The call is then transferred to
that number. If nobody answers the transferred call within the timeout time, the call is
transferred again to phones according to the setting of [PBX settings / Extension]
X Operation at calling side in the automatic transfer function
1) Call this vessel (AMBE+2). You are requested to dial extension number.
2) Dial extension number (4 digits). The extension number is called.
3) When the party answers, pick up the receiver.
4) Hang up the receiver after completing the call.
To Next Page
Loading...
Need help?
General
