Garmin GTX 330 User Manual

190-00207-02 GTX 330/330D Installation Manual
Revision U Page D-14
APPENDIX D INTERCONNECT DRAWINGS
Figure D-10 Dual TXP to GTN 6XX/7XX Interconect Wiring Diagram, Encoding Altitude Connections (Sheet 2 of 2)
GARMIN GARMIN
GTN 6XX/7XXGTN 6XX/7XX
GARMIN GARMIN
GTX 330 #1GTX 330 #1
GARMIN GARMIN
GTX 330 #2GTX 330 #2
J3301 P3301J3301 P3301
2323
2222
5151
1111
2
4
5
7
9
10
10
8
3
6
5050ALTITUDE COMMON (GROUND)ALTITUDE COMMON (GROUND)
6262
1111
2
4
5
7
9
10
10
8
3
6
62
62
5050
ALTITUDE COMMON (GROUND)ALTITUDE COMMON (GROUND)
2323
2222
5151
4. 4. IF THE GTN IS TO CONTROL THE GTX 330 UNITS, THE GTX 330 UNITSIF THE GTN IS TO CONTROL THE GTX 330 UNITS, THE GTX 330 UNITS
AIRCRAFT GROUNDAIRCRAFT GROUND
GARMIN SHIELD BLOCK GROUNDGARMIN SHIELD BLOCK GROUND
(REFER TO 190-00313-09)(REFER TO 190-00313-09)
5. ANY AVAILABLE GTN 6XX/7XX RS-232 PORT MAY BE USED.5. ANY AVAILABLE GTN 6XX/7XX RS-232 PORT MAY BE USED.
J3301 P3301J3301 P3301
S
S
S
MUST USE SOFTWARE VERSION 6.11 OR HIGHER.MUST USE SOFTWARE VERSION 6.11 OR HIGHER.
NOTES:NOTES:
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE NOTED.1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE NOTED.
2. THE GTX 330 CONTAINS INTERNAL ALTITUDE CODE LINE ISOLATION DIODES.2. THE GTX 330 CONTAINS INTERNAL ALTITUDE CODE LINE ISOLATION DIODES.
EXISTING INSTALLATIONS WITH DIODES INSTALLED IN THE WIRE HARNESS MAYEXISTING INSTALLATIONS WITH DIODES INSTALLED IN THE WIRE HARNESS MAY
BE USED "AS IS" WITHOUT REMOVING THE DIODES.BE USED "AS IS" WITHOUT REMOVING THE DIODES.
3. FOR ENCODER POWER INPUT USE DIODES OF AT LEAST 3 AMP, 50 VOLTS3. FOR ENCODER POWER INPUT USE DIODES OF AT LEAST 3 AMP, 50 VOLTS
REVERSE RATING.REVERSE RATING.
P1001 J1001P1001 J1001

Garmin GTX 330 Specifications

General

Reply Frequencies	1090 MHz
Frequency Range	1090 MHz (reply)
Power Output	200 Watts peak
Dimensions	5.7 x 1.6 x 7.5 inches (145 x 41 x 191 mm)
Temperature Range	-20°C to +55°C
Operating Voltage	11-33 VDC