GE D25 User Manual

GE Grid Solutions
D25
User's Manual
GE Information 994-0081-3.00-21
111
Fuse Replacement
Fuse Locations
In addition to the main power supply fuses, all Digital Input and Digital
output modules are equipped with field replaceable fuses. Fuse locations for
a typical D25 with 3 S-boards and a DB-25 terminated K-board:
ON
OFF
POWER
A
D25 MAINT
IED 1
IED 2
UTC
C
E
B
D
F
H
DC ANALOG
INPUTS
GND
XCOM 1
XCOM 2
SYSFAIL AUX KEY
2 1 2 1 2 1
RADIO
J1
J2
J3
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40
P1 P3 P5 P7 P9
P2 P4 P6 P8
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40
WETTING
FUSE
F6
INPUT
FUSES
POWER SUPPLY
CONNECTOR
GROUNDING
POINT for D25
POWER
SWITCH
WETTING
POWER
SUPPLY
FUSE
F2
F3
F4
F5
STATUS
SUPPLY
FUSE
F1
!
!
!
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40
CONTROL
Note: For fuses used by the K-4Z control module, See below: Table:
Replaceable Fuses
Note
Fuses listed in the table below are the standard fuses that are factory installed,
unless otherwise specified.
Fuse ratings may differ due to:
• Unique customer-specific configurations or requirements, or
• Product specification changes
When changing fuses, always check original fuse for value and type, and
ensure the replacement fuse you use is of that value and type. Do not assume
that installed fuse is of the correct value.

GE D25 Specifications

General

Brand	GE
Model	D25
Category	Controller
Language	English