GE Grid Solutions
994-0081-3.00-21 GE Information
Set Up of a Color GDP (CGDP)
Overview
This section describes how to set up the Color Graphical Display Panel
(CGDP) on your D25*. The CGDP uses a licensed software package named
the GDP 300 from Quasar Controls, which you must register as part of the
setup procedure. The CGDP software includes system firmware named the
Substation Bay Viewer™ 300 (SB Viewer 300) that runs on the D25 CGDP
and a Windows-based editor named the Substation Bay Config Tool™ 300
(SBC Tool 300) that runs on a PC.
The diagram below shows the relationship between the PC, D25 and CGDP
(SB Viewer 3 00). The SB Viewer 300 and D25 communicate with each
other using the DNP protocol over RS-485. The SB Viewer 300 is configured
using the SBC Tool 300 running on the PC. The D25 is configured using
SGConfig which also run on the PC.
PC
SGConfig
SBC Tool
300
D25 CGDP
RS-485
D25 Configuration
SB Viewer 300
(DNP DCA)
DNP PACKETs
SB Viewer 300 Configuration
DNP DPA
Prerequisites
Install the:
• Compact Flash Card (GE part number 160-0125) which includes
Windows Embedded CE and SB Viewer 300
• SBC Tool 300 in Windows 7 or Windows Server 2008
To Next Page
Loading...
Need help?
General
