NX-10 User Manual 21
Setting the system time and date
2. The current time is shown as day of the week, hours, minutes.
Depending on configuration set by the installer, the clock is displayed
as 12- or 24-hour clock. The current date is shown as dd.mm.yyyy.
3. Press the
key to increase the hour or press the key to decrease it.
You can also enter digits from the keypad.
4. Press OK to accept the change and move on. Press NO to cancel the
change.
1. Scroll to Set Date/Time and press OK.
To set the system time and date, press OK and enter a user code. Navigate with the keys to Set Date/Time and press OK.
OK
NO
Fri 11:56
27 Jun 2008
........
........
........
........
OK
To Next Page
Loading...
Need help?
General
