To Next Page

To Previous Page

NX-10 User Manual 30

If you have a proximity reader installed, you can use a proximity card to activate various keypad functions by holding the card against

the reader. As a master user, you can add one or multiple cards to the system or delete existing cards. To do this, press OK and enter a

master code. Navigate with the

 keys to NX-1701 Proximity Readers and press OK.

2. Enter the user number to be assigned to the card and press OK.

LED 1 on any enabled readers begins to flash.

3. Scan the card. If it is not already in the system, it is added and LED 1

stops flashing. If it is not in the system, the reader triple beeps.

4. To add multiple cards, navigate with the  keys to Add Multiple

Cards and press OK. Carry out step 2 and scan the first card.

5. If the user card is not already in the system, it is added and LED 1

continues flashing, indicating that the next card can be scanned.

6. To delete a card, navigate with the  keys to Delete One Card and

press OK. Carry out step 2 and scan the card.

7. The user card information for the re-entered user number is cleared

and LED 1 stops flashing.

Note: 40 seconds after you have finished scanning cards, all the readers in

the system are updated with the new card information.

1. To add one card, navigate with the  keys to Add One Card and

press OK.

Adding and deleting cards

........



Enter User No.

123



GE NX-10 User Manual

Other manuals for GE NX-10