NX-10 User Manual 25
Changing phone numbers
2. A list of three available phone numbers (1 to 3) is displayed. Scroll to the
relevant phone number and press OK.
3. Press F4 (
) or F5 ( ) to scroll to the required digit.
Press the
key to delete a single digit.
4. Press # to move to the start of the phone number and then press #
to delete the whole number.
5. Enter a new number and press OK.
1. Navigate with the keys to Phone Numbers and press OK.
In certain cases, you can change the phone number to which reports are sent. This way an alarm signal can be sent to your phone. You can
do this only if the existing phone numbers are configured to use either Siren Tone or voice protocol, and user phone editing is enabled by
the installer. Press OK and enter your user code.
OK
/
OK
........
........
........
........
Phone Numbers
Phone Number 1
........
#
#
To Next Page
Loading...
Need help?
General
