NX-10 User Manual 29
Testing your system
2. A chime sounds when you activate a zone and the zone status is
displayed on the LCD. If it is not, try to activate the zone again.
3. Enter your master user code to exit the walktest.
4. To view any system problems, such as a battery fault or damaged
phone line, scroll to Service Check and press OK.
5. If there are any problems, a service message is displayed on the LCD.
See page 31 for more information.
Note: Use the
keys to scroll through the walktest and service check
results on the LCD display.
1. To test each sensor in your system, after entering a master user code,
scroll to Walktest and press OK. Enter each zone and check its sensors
(doors/windows).
You can perform various tests on your system to ensure that it is working correctly. To perform a service check, it is enough to enter the
Quick User Menu. To perform a walktest, you have to enter a master user code.
........
........
........
........
........
OK
Walktest
<results>
OK
Service Message
........
........
........
........
........
To Next Page
Loading...
Need help?
General
