4-4 Patient Data Module 2030047-001A
Service Tool and Configuration
Change the PC’s IP address
NOTE
Disable all network ports on the PC except the Patient Data Module connection.
Disable firewall and networking services
If your PC is running any firewall protection or networking services, such as Cisco
Systems VPN, BlackICE, Security Accounts Manager or a wireless network card,
perform the following procedure to disable these services on the PC.
1. Select one of the following from the toolbar:
In Windows XP, select Start > Control Panel > Administrative Tools >
Services.
In Windows 2000, select Start > Settings > Control Panel > Administrative
Tool s > Services.
2. In the list of available firewall and networking services, double-click the service
(e.g. Black ICE and Security Accounts Manager) to be disabled.
Windows XP Windows 2000
1. From the toolbar, select Start > Run
2. Type cmd and press Enter.
3. Type ipconfig<space>/all and press Enter.
4. If the IP address and subnet mask are defined, record them:
IP address: _______________________________________
Subnet mask: _________________________________________
5. From the toolbar, select Start >
Control Panel > Network
Connections.
From the toolbar, select Start > Settings > Control Panel >
Network and Dial-up Connections.
6. Right-click Local Area Connection.
7. Select Properties.
8. Select Internet protocol (TCP/IP).
9. Click Properties.
10. Select Use the following IP address.
11. In the IP address field, type 192.168.252.95.
12 In the Subnet mask field, type 255.255.255.0
13. If prompted to restart the PC, select Yes.
18. Continue with the instructions, Disable firewall and networking services on page 4-4.
To Next Page
Loading...
Need help?
General
