GE Senographe DS Operator's Manual

GE Healthcare Senographe DS Acquisition System
Revision 1 Operator Manual 5307907-3-S-1EN
Startup and Shutdown
6-startup.fm Page no. 49 Chapter 6
Chapter 6 Startup and Shutdown
1 Startup procedure
To power up the system, press the power switch I on the X-ray Console. Power is applied to the whole sys-
tem (Gantry, Control Station, Digital Detector, etc.); green power indicators are lit on the Generator, the Con-
trol Station, and the monitor.
• A series of system initialization messages appears on the Workstation screen, then the Login: prompt is
displayed. Type sdc (all lower case) followed by <Enter>. The AWS login screen shown below is dis-
played after a short delay.
• Enter your user name in Login ID field. Then enter your password as provided by the system administra-
tor.
Note:
When the system is delivered two accounts are available:
- A user account; user name clinical, password clinical.
- An administrator account; user name admin, password admin.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

GE Senographe DS Specifications

General

Brand	GE
Model	Senographe DS
Category	Medical Equipment
Language	English