Safety considerations
Vivid T9/Vivid T8 – Basic Service Manual 1-13
5795591-100 English Rev. 3
1-6 Safety considerations
1-6-1 Contents in this section
• 1-6-2 ‘Introduction’ on page 1-13
• 1-6-3 ‘Human Safety’ on page 1-13
• 1-6-4 ‘Mechanical safety’ on page 1-16
• 1-6-5 ‘Electrical safety’ on page 1-19
1-6-2 Introduction
The following safety precautions must be observed during all
phases of operation, service and repair of this equipment.
Failure to comply with these precautions or with specific
warnings elsewhere in this manual, violates safety standards of
design, manufacture and intended use of the equipment.
1-6-3 Human Safety
• Operating personnel must not remove the system covers.
• Servicing should be performed by authorized personnel
only.
Only personnel who have participated in a Vivid T9/Vivid T8
Training Seminar are authorized to service the equipment.
DANGEROUS VOLTAGES, CAPABLE OF CAUSING
DEATH, ARE PRESENT IN THIS EQUIPMENT. USE
EXTREME CAUTION WHEN HANDLING, TESTING
AND ADJUSTING.
If the covers are removed from an operating Vivid T9/Vivid T8,
some metal surfaces may be warm enough to pose a potential
heat hazard if touched, even while in shutdown mode.
To Next Page
Loading...
Need help?
General
