gefran ADL510 User Manual

ADL500 • Quick installation guide - Specifications and connection 55
 ENUM parameters
The parameter may assume only the values contained in a selection list.
04.01
DRIVE MONITOR
04.02
DRIVE INFO
04.03
DRIVE CONFIG
04.04
ALARM CONFIG
E
x2
03 /18
PAR: 540
Control type
ASY SSC
Value: 0
E
03 /18
PAR: 540
Control type
ASY SSC
Value: 0
 
03 /18
PAR: 540
Control type
SYN FOC
Value: 4
03 /18
PAR: 540
Control type
ASY SSC
Value: 0
Press E

Press EESC to cancel.
 Execution of commands
A parameter can be used to carry out a number of operations on the drive. For an example, see next paragraph: in this
case the request "Press E to execute" is displayed.
To execute the command, press E. During execution of the command, the “In progress
indicate that the operation is in course. At the end of execution, if the result is positive, the “Done
for few seconds. If execution has failed, an error message is displayed.
8.2.7 How to save parameters
There are two ways of saving parameters in the non-volatile memory of the drive:
1) By pressing the SAVE key on the keypad.
2) Menu CONFIG DRIVE, parameter Save parameters, PAR : 550. This is used to save changes to parameter set-
󰀨
04.01
DRIVE MONITOR
04.02
DRIVE INFO
04.03
DRIVE CONFIG
04.04
ALARM CONFIG

01 /18
PAR: 550
Save parameters
Press E to execute
E
01 /18
PAR: 550
Save parameters
In Progress
01 /18
PAR: 550
Save parameters
Done


gefran ADL510 Specifications

General

Brand	gefran
Model	ADL510
Category	Inverter
Language	English