13
GB 05 04 04
Sprayer setup
6. Extend or retract the axle.
A sack barrow and a
rod will facilitate the
operation.
7. If the rim position must be changed (described later in
this chapter) do this first and fine adjust by extending
or retracting the axles. Remember to tighten the
wheel nuts to the specified torque:
Rim plate to rim: 280 + 30 Nm (207 + 22 lbft)
Rim plate to hub: 490 Nm (288 lbft)
8. Tighten the clamp bolts to a torque of:
280 Nm (207 lb.ft) for 2200/2800
390 Nm (289 lbft) for 3200/4200.
9. Tighten nut B again.
IMPORTANT! Place the jack under the axle and lift the
wheel to remove load from the clamps before tightening
the clamp bolts to the specified torque.
10. Repeat the procedure on RH wheel.
11. Check the distance from centre tyre to centre of tank
frame is equal at RH and LH.
12. Retighten clamp bolts and wheel bolts to specified
torque after 8 hours of work.
T251-0005
TT
TT
T
rr
rr
r
acac
acac
ac
k gk g
k gk g
k g
augaug
augaug
aug
ee
ee
e
Altering the trAltering the tr
Altering the trAltering the tr
Altering the tr
acac
acac
ac
k gk g
k gk g
k g
augaug
augaug
aug
ee
ee
e
The track gauge of the COMMANDER can be altered
stepless as follows,
1. Measure the current track gauge (centre RH tyre to
centre LH tyre). Each side must be extended or
retracted half the desired alteration.
2. Attach the sprayer to tractor and engage tractor
parking brake.
3. Place stop wedges in front
of and behind RH wheel.
Jack up LH wheel, support
and secure sprayer body.
4. Loosen clamp bolts
for LH wheel axle.
5. Loosen the nut B on the brake operating arm.
Extend/retract this arm according to the adjustment of
the axle.
T112-0005
COMMANDER
without suspension
COMMANDER
with suspension
T251-0006
To Next Page
Loading...
Need help?
General
