To Next Page

To Previous Page

GB 05 08 01 05

Sprayer setup

ansporanspor

anspor

t loct loc

t loc

When the boom is unfolded: Inspect the gap between

the bolt A and the frame. Correct position = 1 mm gap.

If necessary, adjust the position of bolt A.

T060-0128

T271-0014

Adjusting boom trAdjusting boom tr

Adjusting boom tr

ansporanspor

anspor

t positiont position

t position

If the boom wings do not rest accurately in the transport

brackets, the wings can be adjusted as described below:

1. Lift the boom all the way to the top.

2. Fold the boom into transport position. With the fold

cylinder pressurized, determine if the boom wings

need to be adjusted inwards or outwards.

3. Relieve the pressure from the fold cylinder by unfold-

ing the boom a few centimetres.

4. If the boom rests to far in on the transport brackets,

loosen the nut B and adjust collar A in towards the

cylinder housing.

5. If the boom rests too far out on the transport brackets,

the collar A has to go out from the cylinder housing.

6. Secure jam nut B.

7. Pressurize the cylinder to see if the boom is properly

adjusted. If not, repeat the above procedure until it is

correctly adjusted.

T064-0101

T142-0026

Hardi Commander Plus SPC Series User Manual

Questions and Answers: