2G40, 2G40 H Operation and use
HATZ
33Operator’s Manual
Max. permissible forces at the speed control and stop levers
7.2 Performing tests
Before starting
Before starting the engine, several tests need to be performed to ensure the
machine is working properly.
Procedure
Step Test
1 The machine is standing securely and on a level surface.
2 The installation location is adequately ventilated.
3 There is a sufficient amount of fuel in the fuel tank (see chapter
7.7 Refueling, page 46).
4 There is a sufficient amount of engine oil in the engine housing
(see chapter 6.4 Filling engine oil (first filling), page 29).
5 Fill the oil bath air filter (option) with engine oil (see chapter 6.5
Filling the oil bath air filter (option), page 31).
6 No persons are located in the danger zone of the engine or ma-
chine.
7 All safety equipment is in place.
To Next Page
Loading...
Need help?
General
