Network Video Recorder User Manual
127
Step 5 Select the channel(s) in Trigger Channel settings you want to make full screen monitoring.
ï€
Auto-switch will terminate once the alarm stops and back to the live view interface.
11.2.2 Configure Audio Warning
The audio warning enables the system to trigger an audible beep when an alarm is detected.
Step 1 Go to System > Live View > General.
Step 2 Enable the audio output and set the volume.
Step 3 Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, facial detection, etc.).
Step 4 Select the Audio Warning alarm linkage action.
11.2.3 Notify Surveillance Center
The device can send an exception or alarm signal to the remote alarm host when an event occurs.
The alarm host refers to the PC installed with client software (e.g., iVMS-4200, iVMS-5200).
Step 1 Go to System > Network > Advanced > More Settings.
Step 2 Set the alarm host IP and alarm host port.
Step 3 Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, facial detection, etc.).
Step 4 Select the Notify Surveillance Center.
11.2.4 Configure Email Linkage
The system can send an email with alarm information to a user or users when an alarm is
detected.
Please refer to Chapter 16.7 Configure Email for details of Email configuration.
Step 1 Go to System > Network > Advanced.
Step 2 Configure the Email settings.
Step 3 Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, facial detection, etc.).
Step 4 Select the Send Email alarm linkage action.
11.2.5 Trigger Alarm Output
The alarm output can be triggered by the alarm input, motion detection, video tampering
detection, facial detection, line crossing detection, and all other events.
To Next Page
Loading...
Need help?
General
