Network Video Recorder User Manual
55
3.2 Enable H.265 Stream Access
The device can automatically switch to the H.265 stream of IP camera (which supports H.265 video
format) for the initial access.
Step 1 Go to More Settings > H.265 Auto Switch Configuration at the top taskbar.
Step 2 Check Enable H.265 (For Initial Access).
Step 3 Click OK.
3.3 Upgrade the IP Camera
The IP camera can be remotely upgraded through the device.
ï€
Plug the USB flash drive with the IP camera’s firmware upgrade file to the device.
Step 1 On the camera management interface, select a camera.
Step 2 Go to More Settings > Upgrade at the top taskbar.
Step 3 Select the firmware upgrade file from the USB flash drive.
Step 4 Click Upgrade.
Step 5 The IP camera will reboot automatically after the upgrading completes.
3.4 Edit Channel Default Password
Purpose:
You can activate and add IP camera by the channel default password.
Step 1 On the camera management interface, select a camera.
Step 2 Go to More Settings > Channel Default Password Management at the top taskbar.
Step 3 Check Change Password.
Step 4 Edit Channel Default Password.
We highly recommend you create a strong password of your own choosing (Using a minimum of 8
characters, including at least three of the following categories: upper case letters, lower case
letters, numbers, and special characters.) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security system, resetting the
password monthly or weekly can better protect your product.
To Next Page
Loading...
Need help?
General
