DS-7108HI-S series Net DVR User Manual
21
DVR will adjust the corresponding preset number. Repeat pressing [REC] key, and press the
preset number, DVR will adjust that preset number.
When you exit PTZ control mode, the camera will stay at the current position.
Note: The PTZ preset number is set already. Please refer to PTZ menu for preset setup. V2.0
firmware can support 128 preset at most and the number of preset may 96 when you use the USB
mouse to call them
Start/Stop auto function in PTZ control mode
In PTZ control mode, press [PLAY] key to start PTZ auto function. Press [PLAY] key again
to stop.
When PTZ is in auto mode, if you exit PTZ control mode, PTZ will continue auto function
unless you enter the PTZ control mode again, and press [PLAY] key to stop.
Exit PTZ control mode
Press [ESC] or [ENTER] to exit and return to the preview mode.
4.6 Manual Record
Note: The user must have the corresponding right, DVR has HDD and HDD is formatted
already.
Manual record
In preview mode, press [REC] key, in the pop-up login dialog, select the name and input the
correct password, you can enter the “Manual Record” interface.
In menu mode, press [REC] key to enter the “Manual Record” interface directly.
Fig. 4.8 Manual record interface
Description
Manual record interface has follows parts: channel number, channel status, start/stop record,
start all and stop all buttons.
To Next Page
Loading...
Need help?
General