DS-7108HI-S series Net DVR User Manual
36
Step 2: Select camera: Please use [] [] keys to select one camera.
Step 3: Adjust brightness, contrast, saturation and hue: Move “Active Frame” to the “Adjust”
button on the right side of Brightness, Contrast, Saturation and Hue, press [ENTER]key, you will
enter the corresponding adjust interface. In the adjust interface, there is one scroll bar at the
bottom, you can use [] [] keys to adjust and can find the video image will be changed at the
same time. When you are satisfied with the real time video image, press [ENTER] to return
“Color” menu.
Step 4: You can copy the video parameters of current camera to any other cameras. Or you
can repeat setp2 and step3 to adjust for any other camera.
After adjusting, in “Color Setup” menu, press “Confirm” button to save parameters and make
them become effective. Otherwise, press “Cancel” button or [ESC] key to invalidate modification.
5.7 Mask Area Setup
In some cases, maybe you want to mask the sensitive area. This area will not be previewed
and recorded. The mask area setup steps are following:
Step 1: Enter “Camera” menu:
Step 2: Select one camera: You can use [] [] keys to select one camera.
Step 3: Enter “Advanced settings” enable the check box beside “Privacy Mask” item, you can
press [Enter] or [edit] key to change the flag into “”, and active “Area” button. Move “Active
Frame” to “Area” button on the right side of mask check box, press[ENTER]key to enter mask
area setup interface. Shown as Fig.5.14 below
Fig. 5.14 Mask area setup
Step 4: Setup mask area: In the mask area setup interface, there is one small yellow pane on
To Next Page
Loading...
Need help?
General