DS-7108HI-S series Net DVR User Manual
64
Fig. 7.9 Setup home directory
7. Next time, you need not setup again, just double click and open “wftpd32.exe” to
upgrade the DVR/DVS firmware.
7.2 Upgrade Mode
1. Use client software to upgrade the firmware file. Please refer to the client software user
manual for detail information.
2. Use “FTP” function of “Upgrade” sub menu in “Utilities” menu. Before that you need
one host PC to run FTP server software and place firmware file (digicap.dav), and make
sure DVR and PC are in the same subnet. Please refer to 7.1 FTP Server Setup on how
to setup wftpd32 server first.
3. Use “USB” function of “Upgrade” sub menu in “Utilities” menu. Please make sure the
firmware file (digicap.dav) is placed under root directory of USB flash memory.
4. Use RS-232 serial ports to upgrade the firmware file. Please take the following steps:
Step1: Download the TFTP server from the internet, such as Cisco TFTP Server. Then
run it and put the firmware in the root directory of the Cisco TFTP Server.
Step2: Use the serial cable to connect device’s RS232 serial ports with COM port of
server PC
Step3: Run and configure the Hyper Terminal. The parameters are: Baud rate: 1
15200bps, Data bit: 8 bits, Stop bit: 1 bit, Parity: No, Flow ctrl: None.
To Next Page
Loading...
Need help?
General