51
3. Configure the settings for selected output.
4. Select OK to save and exit.
Note: If the Hold For option is selected as Manually Stop, the alarm will only stop when you manually stop it
(See Triggering Alarm Outputs Manually).
Note: Triggering an IP camera will require the necessary permissions from the camera.
Triggering Alarm Outputs Manually
You may also trigger alarm outputs manually through the Manual Alarm menu.
To trigger alarm outputs manually:
1. Click Menu > Manual Alarm to enter the Manual Alarm menu (Figure 11).
Figure11. Manual Alarm Menu
2. Configure the following settings in the Manual Alarm menu:
• Trigger: Select an alarm from the list and click Trigger to trigger its output.
• Trigger All: Trigger all alarm outputs at once.
• Clear All: Stop all alarm outputs at once.
3. Select OK to return to the previous menu.
Detecting Video Loss
Your DVR can be set up to detect video loss and trigger an action. To set up video loss detection:
1. Click Menu > Settings >Camera Management menu, shown in Figure 12.
To Next Page
Loading...
Need help?
General