78
Set HDD Groups
Your DVR can separate multiple HDDs into groups. Videos from specified channels can be set to be recorded onto
a particular HDD group.
To set up a HDD group:
1. Click Menu > HDD to enter the HDD Management menu.
2. Select HDDs to be added to group.
3. Select Group button to enter Group Settings menu.
4. Set the HDD Group Number, as shown in Figure 5.
Figure5. HDD Group Settings Menu
5. Select OK to save settings and exit the Group Settings menu.
Note: By default settings, all HDDs belong to group 1.
Set HDD Status
You may change the behavior of your HDD by changing its status. The status of a HDD can be set to redundancy,
read-only or read/write (R/W).
Setting HDD to Read-Only
A HDD can be set to read-only to avoid important recorded files from being overwritten when the HDD becomes
full.
To set a HDD to read-only:
1. Click Menu > HDD to enter the HDD Management menu.
2. Select HDD to be protected.
3. Select the Set button to enter the HDD Settings menu, as shown in Figure 6.
To Next Page
Loading...
Need help?
General