70
Configure IP Cameras
1. DS-7604HI-S model can be used as the hybrid DVR or NVR.
When DS-7604HI-S is used as a hybrid DVR, it can be connected with 4 analog cameras and 2 IP
cameras at 4CIF or 1 IP camera at UXGA/1080P/720P resolution.
When DS-7604HI-S is used as a NVR, it can be connected with 4 IP cameras at 4CIF or 2 IP cameras
at UXGA/1080P/720P or 1 IP camera at 2560×1920 resolution.
2. DS-7604NI-S/M and DS-7604NI-S models provide no analog camera connection; therefore it can be
used as NVR only, allowing 4 IP cameras at 4CIF or 2 IP cameras at UXGA/1080P/720P or 1 IP
camera at 2560×1920 IP resolution to be connected.
3. DS-7608NI-S provide no analog camera connection; so it could be used as NVR only, allowing 8 IP
cameras at 4CIF or 4 IP cameras at UXGA/1080P/720P or 2 IP cameras at 2560×1920 resolution to be
connected.
Note: Each IP camera is allowable to be connected to a single DS-7604 unit so as to avoid confused control.
Before configuring IP cameras, please ensure that all IP cameras are connected to the same network as your DVR
and the network settings for your DVR is properly set up (See Configuring Network Settings).
To configure IP cameras:
1. Click Menu > Settings > Camera to enter the Camera Management menu, shown in Figure1.
Figure1. Camera Management Menu
2. Select the channel to be connected from the Camera Management menu.
Note: When you want to connect more than 2 IP cameras at 4CIF resolution or 1 IP camera at
720P/UXGA/1080P/2560×1920 resolution with the DS-7604HI-S unit, it needs to adjust the
number of analog cameras connected. 1 IP cameras at 4CIF resolution can be added by disabling
2 analog channels; and 2 IP cameras at 4CIF resolution or 1 IP camera at
720P/UXGA/1080P/2560×1920 resolution can be added by disabling 4 analog channels. Up to 4
IP cameras at 4CIF resolution, or 2 IP cameras at 720P/UXGA/1080P, or 1 IP camera at
2560×1920 resolution can be connected to the DS-7604HI-S unit.
Operate the following steps to adjust the analog camera status:
a) Click the Status button from the Camera Management menu to enter the following dialog box:
Note: Only DS-7604HI-S has the Status button and menu.
To Next Page
Loading...
Need help?
General