User Manual of Digital Video Recorder
119
9.2 Configuring Advanced Settings
9.2.1 Configuring PPPoE Settings
Purpose:
Your device also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the PPPoE tab to enter the PPPoE Settings interface.
Figure 9. 2 PPPoE Settings Interface
3. Check checkbox to enable PPPoE.
4. Enter User Name, Password, and Confirm Password for PPPoE access.
Note: The User Name and Password should be assigned by your ISP.
Figure 9. 3 PPPoE Settings Interface
5. Click to save and exit the interface.
6. After successful settings, the system asks you to reboot the device to activate the new settings, and the
PPPoE dial-up is automatically connected after reboot.
You can go to Menu > Maintenance > System Info > Network interface to view the status of PPPoE
connection. Please refer to Chapter 12.1.5Viewing Network Information for PPPoE status.
9.2.2 Configuring DDNS Settings
Purpose:
If your device is set to use PPPoE as its default network connection, you may set Dynamic DNS (DDNS) to be
used for network access.
Prior registration with your ISP is required before configuring the system to use DDNS.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the DDNS tab to enter the DDNS Settings interface.
To Next Page
Loading...
Need help?
General