User Manual of Digital Video Recorder
124
9.2.4 Configuring SNMP Settings
Purpose:
You can use SNMP protocol to get device status and parameters related information.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the SNMP tab to enter the SNMP Settings interface.
Figure 9. 14 SNMP Settings Interface
3. Check checkbox to enable SNMP.
4. Configure the SNMP settings.
Figure 9. 15 Configure SNMP Settings
5. Click to save and exit the interface.
Note: Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the device is allowed to send the alarm event and
exception message to the surveillance center.
9.2.5 Configuring UPnP™ Settings
Purpose:
Universal Plug and Play (UPnP™) can permits the device seamlessly discover the presence of other network
devices on the network and establish functional network services for data sharing, communications, etc. You can
use the UPnP™ function to enable the fast connection of the device to the WAN via a router without port
mapping.
Before you start:
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of the router to
which your device is connected. When the network working mode of the device is set as multi-address, the
To Next Page
Loading...
Need help?
General