Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
100
and troubleshoot the security events.
Steps
Note
This function is only supported by certain camera models.
1. Go to Configuration → System → Maintenance → Security Audit Log.
2. Select log types, Start Time, and End Time.
3. Click Search.
The log files that match the search conditions will be displayed on the Log List.
4. Optional: Click Export to save the log files to your computer.
Set Log Server
The log server should support syslog (RFC 3164) over TLS.
Before You Start
● Install client and CA certificates before configuration. Refer to Certificate Management for
detailed information.
● Select certificates according to the requirement of the log server. If two-way authentication is
required, select the CA certificate and the client certificate. If one-way authentication is
required, select the CA certificate only.
Steps
1. Check Enable Log Upload Server.
2. Optional: Check Enable Encrypted Transmission if you want the log data to be encrypted.
3. Input Log Server IP and Log Server Port.
4. Optional: Select client certificate.
5. Select CA certificate to the device.
6. Click Test to test the settings.
7. Click Save.
Certificate Management
It helps to manage the server/client certificates and CA certificate, and to send an alarm if the
certificates are close to expiry date, or are expired/abnormal.
Note
The function is only supported by certain device models.
14.15.3 Set IP Address Filter
IP address filter is a tool for access control. You can enable the IP address filter to allow or forbid
To Next Page
Loading...
Need help?
General
