Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
32
6.3 Set Scene Auto-Switch
The device supports patrol among the scenes and performs the set detection. Patrol sequence and
dwelling time in each scene are configurable.
Before You Start
Finish scene settings in advance. See Set a Detection Scene for configuration instructions.
Steps
1. Go to Ship Detection → Scene Auto-Swtich to configure this function.
2. Set the scene patrol sequence.
Scene Name
Select a scene name from the drop down list.
Dwell Time
Set the dwell time of the scene when doing patrol tracking.
Overstaying Alarm Time
Set the overstaying alarm time of the scene when doing patrol tracking.
3. Click the up, down arrow to adjust the patrol sequence.
4. Click Save.
6.4 Advanced Parameters
Go to Configuration → Ship Detection → Advanced Settingsand configure the parameters.
Detection Parameters
Object Detection Threshold
The higher the value is set, the more easily the target will be detected.
Generation Speed
The higher the value is set, the faster the target generation speed will be.
Restore Parameters
Restore Default
Click Restore to restore the parameters to the default values.
Restart Algorithm Library
Click Restart to restart the Algorithm Library.
Note
The settings vary according to different models.
To Next Page
Loading...
Need help?
General
