Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
47
Steps
1. Click to show the setting panel, and click to enter patrol setting interface.
2. Select a patrol number from the list and click .
3. Click to add presets.
Preset
Select predefined preset.
Speed
Set the speed of moving from one preset to another.
Time
It is the duration staying on one patrol point.
Delete the presets in patrol.
Note
A patrol can be configured with 32 presets at most, and 2 presets at least.
4. Click OK to finish a patrol setting.
5. Repeat the steps above to configure multiple patrols.
6. Operate patrols.
Note
You can delete all patrols in Configuration → PTZ → Clear Config. Click Clear All Patrols, and
click Save.
9.3.1 Set One-Touch Patrol
The device automatically adds presets to one patrol path and starts patrol scan.
Steps
1. Set two or more presets except special presets. For setting presets, refer to Set Preset.
The device will automatically add presets to patrol path No.8.
To Next Page
Loading...
Need help?
General
