Deskstar T7K500 Hard Disk Drive Specification
201
12.30 Security Disable Password (F6h)
Table 119: Security Disable Password (F6h)
The Security Disable Password command disables the security mode feature (device lock function).
The Security Disable Password command requests a transfer of a single sector of data from the host including
information specified in the table below. The device then checks the transferred password. If the User Password or
Master Password matches the given password, the device disables the security mode feature (device lock function).
This command does not change the Master Password which may be reactivated later by setting User Password.
This command should be executed in device unlock mode.
Table 120: Password Information for Security Disable Password command
The device will compare the password sent from this host with that specified in the control word.
Identifier Zero indicates that the device should check the supplied password against the user pass-
word stored internally. One indicates that the device should check the given password
against the master password stored internally.
Command Block Output Registers Command Block Input Registers
Register 7 6 5 4 3 2 1 0 Register 7 6 5 4 3 2 1 0
Data - - - - - - - - Data - - - - - - - -
Feature - - - - - - - - Error see below
Sector Count - - - - - - - - Sector Count - - - - - - - -
Sector Number - - - - - - - - Sector Number - - - - - - - -
Cylinder Low - - - - - - - - Cylinder Low - - - - - - - -
Cylinder High - - - - - - - - Cylinder High - - - - - - - -
Device/Head 1 - 1 D - - - - Device/Head - - - - - - - -
Command 1 1 1 1 0 1 1 0 Status see below
Error Register Status Register
7654321 0 76543 21 0
CRC UNC 0 IDN 0 ABT T0N AMN BSY RDY DF DSC DRQ COR IDX ERR
00000V0 0 0V0V- 0- V
Word Description
00 Control word
bit 0 : Identifier (1-Master, 0- User)
bits 1-15 : Reserved
01-16 Password (32 bytes)
17- 255 Reserved
To Next Page
Loading...
Need help?
General