Hitachi PB Series User Manual

3–2 z 3.1 Setting Print Format Section 3
3.1 Setting Print Format
3.1.1 Overview
z This procedure is used to set the line number, line spacing, character size, inter-
character space, character width enlargement.
The available
functions, printable
line count and
character sizes are
different for every
printer model.
3.1.1-1 Line number
z The number of lines to be printed can be set.
z The settable number of lines is either one or two.
z When two lines are printed, the settings on character size, inter-character
space and increased width will be identical for the upper and lower lines.
3.1.1-2 Line spacing
z You can adjust the clearance to the line above.
z The value ranges are listed below:
3.1.1-3 Character size
z The character size can be varied.
z The following character sizes are available:
To change between
the sizes 5 x 8 and
5 x 7, see
 Section 4.2,
"Setting the User
Environment".
NOTE: If no associated character is available after a change of the character size,
a space will be used as substitute.
If the user pattern for
a new selected
character size is not
saved, a space will
be used as
substitute.
3ULQWIRUPDW
6KXW
GRZQ
'HFUH
PHQW
,QFUH
PHQW
%DFN
0DQXDO
6KRZ
FXUVRU
/LQHQXPEHU >  @  OLQH
/LQHVSDFLQJ
>@  GRWV
&KDUDFWHUVL]H
>@ [[[
,QWHUFKDUVSDFH
>@  GRWV
,QFUHDVHGZLGWK
>@  WLPHV
6WDWXV5HDG\
Number of lines Value range
10
2 0 to 2
Character font (in dots)
(width x height in dots)
1 line 2 lines
5 x 8 or 5 x 7 1 to 2 lines 1 to 2 lines
7 x 10 1 to 2 lines 1 to 2 lines
12 x 16 1 line
Type Available character sizes
User pattern 5 x 8, 7 x 10, 12 x 16

Hitachi PB Series Specifications

General

Brand	Hitachi
Model	PB Series
Category	Printer
Language	English