Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
Vehicle Care 147
General Information
Where specified, use only Holden
genuine parts and accessories.
Vehicle Storage
If the vehicle is to be stored for
several months:
.
Wash and wax the vehicle.
.
Clean and preserve rubber
seals.
.
Change engine oil.
.
Drain the washer fluid reservoir.
.
Check coolant and corrosion
protection.
.
Adjust the tyre pressure to the
value specified for a full load.
.
Park the vehicle in a dry, well
ventilated place.
.
Place the shift lever in P (park)
to prevent the vehicle from
moving.
.
Do not apply the park brake.
.
Open the bonnet, close all doors
and lock the vehicle.
Disconnect the clamp from the
negative terminal of the vehicle
battery.
Close the bonnet.
Before returning the vehicle to
the road:
.
Connect the clamp to the
negative terminal of the vehicle
battery.
Check the power windows
operation.
.
Check the tyre pressures.
.
Fill the washer fluid reservoir.
.
Check the engine oil level.
.
Check the coolant level.
Emission Information
The emission control systems are
designed to reduce the amount of
hydrocarbons (HC), carbon
monoxide (CO), and oxides of
nitrogen (NOx) that are emitted from
the engine and fuel system into the
atmosphere. HC and NOx, when
exposed to sunlight under certain
conditions, contribute to
photochemical smog. In addition,
CO is toxic when it becomes highly
concentrated in the air.
Emission Control System
Major emission control systems that
the vehicle may have are:
1. Evaporative emission control
system. This system is
designed to prevent the escape
of fuel vapour from the fuel
system and recycle the
vapours through the normal
combustion process.
2. Crankcase emission control
system. This system is
designed to prevent blow-by
gases from escaping into the
atmosphere and recycle them
through the combustion
process.
3. Exhaust emission control
system. The various
components of this system
operate collectively to limit HC,
CO and NOx emissions in the
exhaust gas. The exhaust
emission control system
consists of components
To Next Page
Loading...
Need help?
General
