Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
Vehicle Care 181
1. Lift up load compartment floor.
Position the tool kit and the
damaged wheel to stand
upright in the load
compartment.
2. Pull the release knob on top of
the rear seatback upwards and
fold the seatback forwards.
3. Place the loop end of the strap
through the seatback latch.
4. Place the hook end of the strap
through the loop and pull it until
the strap is fastened securely
to the seatback latch.
5. Return the seatbacks to their
normal position.
6. Thread the strap through the
spare wheel as shown and
attach the hook to the tailgate
latch.
7. Tighten the strap and secure it
using the buckle.
Jump Starting
Read the following warnings and
procedure in full before attempting
to jump start the vehicle.
If you are still unsure about jump
starting, Holden strongly
recommends for your safety and
that of the vehicle that you seek the
assistance of a suitably trained
service technician.
{
Warning
Do not push start or tow start the
vehicle. If unburnt fuel were to
reach the catalytic converter and
ignite, the converter could
overheat or be destroyed by
backfire. Therefore, if the battery
is flat, jump start, but do not push
start the vehicle.
Batteries produce explosive
gases, contain corrosive acids
and supply levels of electrical
current high enough to cause
(Continued)
To Next Page
Loading...
Need help?
General
