Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
Seats and Restraints 45
Fasten vehicle-approved ISOFIX
child restraint systems to the
ISOFIX mounting brackets.
Note
Ensure that seat belt buckles are
placed out of the way of the
child seat.
ISOFIX mounting brackets are
indicated by a label on the
seatback, as shown. In addition to
the ISOFIX mounting, fasten the
top-tether straps to the top-tether
anchorage points.
Top-Tether Child Restraint
Systems 0 45.
Top-Tether Child
Restraint Systems
The child restraint tether anchors
are located on the backside of the
rear seats and the centre of the rear
end panel at the load
compartment area.
Note
Use the child restraint anchors for
their designed purpose only.
Child restraint installation
The vehicle has been designed to
accommodate child restraints on the
rear seat.
When using a child restraint, read
the installation instructions supplied
with the child restraint and follow the
directions for fitment carefully.
Secure the child in the restraint in
accordance with the manufacturer's
instructions.
If unsure about installing a child
restraint anchor fitting, contact an
approved restraint fitting station or a
Holden Dealer.
To Next Page
Loading...
Need help?
General
