Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
Seats and Restraints 35
8. Insert the rear seat head
restraints into the pockets.
9. Adjust the front seats to the
desired position.
To return the seatback to the upright
position:
1. Lift the seatback upwards and
reinstall the rear head
restraints.
2. Make sure the seat belts are
clear of the latch and push the
seatback firmly back into place.
3. Place the rear part of the seat
cushion in its original position.
Note
Make sure the seat belts are not
twisted or caught under the seat
cushion.
4. Push the front part of the seat
cushion down firmly until it
latches.
Seat Belts
{
Warning
Seat belts are designed to bear
upon the bony structure of the
body, and should be worn low
across the front of the pelvis or
the pelvis, chest and shoulders,
as applicable; wearing the lap
section of the belt across the
abdominal area must be avoided.
(Continued)
Warning (Continued)
Seat belts should be adjusted as
firmly as possible, consistent with
comfort, to provide the protection
for which they have been
designed. A slack belt will greatly
reduce the protection afforded to
the wearer.
Care should be taken to avoid
contamination of the webbing with
polishes, oils and chemicals, and
particularly battery acid.
Belts should not be worn with
straps twisted.
Each belt assembly must only be
used by one occupant. It is
dangerous to put a belt around a
child being carried on the
occupant's lap.
No modifications or additions
should be made by the user
which will either prevent the seat
belt adjusting devices from
operating to remove slack,
(Continued)
To Next Page
Loading...
Need help?
General
