HOLDEN MP SPARK User Manual

Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
164 Vehicle Care
4. Push the bulb into the socket
slightly and rotate
anticlockwise to remove.
5. Insert a new bulb.
6. Insert the bulb holder into the
tail lamp assembly and rotate
clockwise.
7. Install the tail lamp assembly
into the body and tighten the
screws.
8. Check lamp operation.
Side Turn Signal Lights
1. Push the lamp towards the
front of the vehicle and
remove.
2. Rotate the bulb holder
anticlockwise and remove from
the lamp.
3. Pull bulb out of the bulb holder.
4. Insert a new bulb into the
holder.
5. Reinstall the bulb holder into
the lamp and rotate it
clockwise.
6. Reinstall the lamp.
Licence Plate Lamp
1. Unscrew the two screws.
2. Remove the bulb housing by
pulling downwards.
Do not pull on the cable.
3. Rotate the bulb holder
anticlockwise to disengage.
4. Remove the bulb from the
holder.
5. Insert a new bulb.
6. Insert the bulb holder into the
bulb housing and rotate
clockwise.
7. Insert the bulb housing and
replace the two screws.
8. Check lamp operation.

HOLDEN MP SPARK Specifications

General

Brand	HOLDEN
Model	MP SPARK
Category	Automobile
Language	English