Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
Vehicle Care 177
If the tyre pressure has fallen
below 19 psi / 130 kPa, do not
continue driving. Contact a
Holden Dealer.
30. Dispose of the used tyre
sealant canister at a Holden
Dealer or in accordance with
local and State codes and
practices. Replace with a new
canister.
31. Stow the tyre sealant and
compressor kit in the load
compartment.
This is a temporary puncture repair.
Take the vehicle to a Holden Dealer
to have the tyre repaired or replaced
as soon as possible.
Tyre Changing
The vehicle may have a spare tyre.
{
Warning
All passengers must be out of the
vehicle when it is being jacked.
(Continued)
Warning (Continued)
Only jack the vehicle on hard,
level surfaces.
Ensure moving parts of the jack
are adequately lubricated
before use.
Use the jack only at the
designated lifting points. Use in
other locations may result in the
vehicle falling off the jack,
or damage to the vehicle.
Do not start or run the engine
while the vehicle is supported by
the jack.
Use the jack only for lifting the
vehicle when changing wheels.
Do not get under a vehicle that is
supported by a jack. No person
should place any portion of their
body under a vehicle that is
supported by a jack.
The vehicle may have a steel
temporary spare wheel. Drive
carefully and do not exceed
(Continued)
Warning (Continued)
80 km/h. Although the spare tyre
was fully inflated when the vehicle
was new, it can lose air over time.
Check the inflation pressure
regularly.
After installing the spare tyre on
the vehicle, stop as soon as
possible to check the inflation
pressure is correct. Have the flat
tyre repaired or replaced and
installed back on the vehicle as
soon as possible.
{
Warning
Do not drive faster than 80 km/h.
To Next Page
Loading...
Need help?
General
