Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
174 Vehicle Care
.
Repairs damage up to 4 mm in
the tread area of the tyre.
.
Does not repair damage at the
tyre’s side wall, near the rim.
Take the vehicle to a Holden Dealer
to have the tyre repaired or replaced
as soon as possible.
{
Warning
Do not drive faster than 80 km/h.
Do not drive on the repaired tyre
for an extended time. Steering
and handling may be affected.
Note
.
If unusual noises are heard or
the compressor becomes hot,
turn the compressor off for at
least 30 minutes.
.
Check the expiry date on the
tyre sealant canister before use.
The tyre sealant canister must
be replaced before its
expiry date.
.
The compressor and sealant can
be used from approximately
–30 °C to 70 °C.
Temporary puncture repair
1. Apply the park brake.
2. Place the shift lever into either
first or reverse gear, or P.
3. Remove the tyre repair kit from
the compartment under the
floor cover in the load
compartment.
4. Remove the compressor and
the sealant bottle.
5. Remove the electrical
connection cable (A) and air
hose (B) on the underside of
the compressor.
6. Place the switch on the
compressor to
9.
7. Shake the sealant bottle to mix
the sealant.
8. Screw the compressor air hose
to the connection on the
sealant bottle.
9. Connect the compressor plug
to the accessory socket.
10. Start the engine and let it idle
to ensure the battery does not
run down.
Note
If running the engine, ensure neutral
or P is selected.
To Next Page
Loading...
Need help?
General
