75
STARTING THE ENGINE
If the engine is not properly
warmed-up before raising the
engine speed, the warning buzzer
and overheat indicator may
activate and the engine speed will
be automatically reduced.
Before leaving the dock, check the
operation of the emergency stop
switch.
(R2, R3 types)
To prevent damage to the outboard
from overheating, never run the
engine with the propeller out of
water.
When the boat is mounted with the
two outboard motors, perform the
following on the right and left
engines respectively.
1. Insert the emergency stop switch
clip at one end of the emergency
stop switch lanyard into the
emergency stop switch. Attach the
other end of the lanyard securely to
the operator.
Exhaust contains poisonous
carbon monoxide which can
cause unconsciousness and may
lead to death. Never run the
outboard motor in a boat house or
other confined area.
EMERGENCY STOP SWITCH
EMERGENCY STOP
SWITCH CLIP
EMERGENCY STOP
SWITCH LANYARD
STOP
If the operator does not attach the
emergency stop switch lanyard,
and is thrown from the seat or out
of the boat, the out-of-control
boat can seriously injure the
operator, passengers, or
bystanders. Always properly
attach the lanyard before starting
the engine.
42ZVL600.book 75 ページ ２０１８年７月１９日 木曜日 午前９時６分
To Next Page
Loading...
Need help?
General
