9
To “Conguring the settings” (P.8)
(1) Speed Source
You can set the reference speed to be applied when using the
trim support function or cruise control function based on the
boat velocity (Boat Speed) and engine speed (RPM). If you
select Boat Speed, GPS signals must be received.
• When Boat Speed is selected, if GPS signals cannot be
received, the setting will automatically switch to RPM.
In this case, the trim support function and cruise control
function will be canceled.
1. Use the [
∧
] or [
∨
] button to select BOAT SET and press the
[ENTER] button.
2. Use the [
∧
] or [
∨
] button to select Assist Function and
press the [ENTER] button.
3. Use the [
∧
] or [
∨
] button to select Speed Source and
press the [ENTER] button.
4. Use the [
∧
] or [
∨
] button to select Boat Speed or RPM
and press the [ENTER] button.
• When the Speed Source setting is successfully completed,
the COMPLETE pop-up window appears.
• If the Speed Source setting is not completed, the FAILED
pop-up window appears. Retry setting from step 3.
• If no GPS signal is received, the Speed Source item is xed
at RPM as shown below and cannot be changed.
In addition, while the cruise control function is used, Speed
Source cannot be changed.
If none of the above applies and the following screen
appears, check the connection status of the GPS system.
To Next Page
Loading...
Need help?
General
