Honda CB200 User Manual

-
36
-- - - --- ----- N . FRAME---- ---- ----
1. FR ONT WHEEL (DISC BRAKE TYPE)
Fig. 4 - 1
( I ) Cotter pin (3.0 x 28 mm)
( 2) Castle nut (14 mm)
( 3) Speedometer gear box
( 4 ) Gea r box retainer CO\fCr
( S ) Gear hox retainer
( 6) 0-ring (47 mm)
( 7 ) Ball bearing (
6302)
( 8) Front axle distance coUar
( 9 )
Front wheel hub
(10) Tire Oap
( 1
I) F rout wheel rim
(12) Front wheel tuhc
( 13) Front wheel tire
(I 4) Front wheel bearing retainer
(I 5) Oil seal (22 x 36 x 8 mm)
( 16)
Front side collar
(I 7) Front brake disc
( 1
8) Lock washer (6 mm)
(I 9) Front wheel ax le
Disassembly
I. Place a safety stand under the engine 10 raise the front
wheel
off the ground.
2. Remove Lhe setting screw securing tl,e speedorneLer cable
m place: remove the ca ble .
3. Pull out the cotter pin and remove the caslle nuL The
from wheel can then be taken out by pulling oul the
axle.
NOTE:
Do nor apply the brake le,•er wit h t he front wheel off
the machine, as this would abno rmally ad vanoe the
automatic brake adjustment and cause difficulty in
inserting the brake disc between the brake pad.,.
To correct. remove the caliper co, , er and turu out the
adjusting bolt as necessary. (One full rotation of the
adjusting boll increases clearance by I mm (0.0394-in.)
After assembly, have the brake se lf adj••~ted by operat•
ing the brake le,· er se,•eral times.
4. Remove the wheel side collar from the wheel hub oil
seal
5. Straighten the lugs of the lock washers and loosen off
che nuts . Remove the brake disc from the wheel.
Fig. 4 - 2 (I) Selling ,crew (2) Speedometer cable
(3) Front wheel axle
Fig. 4- 3 (I) Side collar
(3) Brake disc
(2) Lock washer

Honda CB200 Specifications

General

Brand	Honda
Model	CB200
Category	Motorcycle Accessories
Language	English