Honda CRF450L 2019 User Manual

Side Stand
Servicing Your Honda 129
Refer to Important Safety Precautions on page 33.
• Check that the side stand assembly is working
properly. If the
side stand is stiff or squeaky,
clean the pivot area and lubricate the pivot bolt
with molybdenum grease.
• Check the spring for damage or loss of tension.
• Check the side stand ignition cut-off system:
1. Sit on the motorcycle and put the transmission
in neutral.
2. Raise the side stand.
3. Start the engine.
4. Pull the clutch lever in.
5. Shift the transmission into gear.
6. Lower the side stand all the way.
The engine should stop as you lower the side stand.
If the engine doesn’t stop, see your dealer for
service.
(1) side stand spring
(1)

Honda CRF450L 2019 Specifications

General

Engine Type	449cc liquid-cooled single-cylinder four-stroke
Bore x Stroke	96.0mm x 62.1mm
Compression Ratio	12.0:1
Fuel System	Programmed Fuel Injection (PGM-FI), 46mm throttle body
Transmission	6-speed
Rear Brake	Single 240mm disc
Front Tire	80/100-21
Rear Tire	120/80-18
Rake (Caster Angle)	28.5°
Wheelbase	58.9 inches
Seat Height	37.1 inches
Fuel Capacity	2.0 gallons
Ignition	Full transistorized ignition
Ground Clearance	12.4 inches
Front Suspension	49mm inverted fork; 12.0 inches of travel
Rear Suspension	Pro-Link Showa single shock, adjustable spring preload, compression and rebound damping
Front Brake	Single 260mm disc
Curb Weight	289 pounds
Valve Train	Unicam four-valve
Final Drive	Chain
Trail	4.6 inches (118mm)