EasyManuals Logo

Honda CRF450L 2019 User Manual

Honda CRF450L 2019
211 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
70 Servicing Your Honda
Engine Oil
1. Run the engine at idle for 3 minutes, then shut
it off.
2. Wait 3 minutes after shutting off the engine to
allow the oil to properly distribute itself in the
engine.
3. Support the motorcycle in an upright position
on a level surface.
4. Remove the engine oil fill cap/dipstick (1)
from the left crankcase cover, wipe it clean,
and insert it without screwing it in. Remove the
oil fill cap/dipstick.
5. Check that the oil level is between the upper
(2) and lower (3) level marks on the engine oil
fill cap/dipstick.
If the oil is at or near the upper level mark,
you do not have to add oil.
If the oil is below or near the lower level
mark, add the recommended oil until it
reaches the upper level mark. (Do not
overfill.)
Reinstall the engine oil fill cap/dipstick.
Repeat steps 1 – 5.
6. Check that the O-ring (4) is in good condition
and replace it if necessary.
7. Reinstall the engine oil fill cap/dipstick (1).
8. Check for oil leaks.
1. Remove the engine guard A bolts/washers (1),
B bolt/washer (2) and engine guard (3).
2. Run the engine at idle for 3 minutes, then shut
it off.
3. Support the motorcycle in an upright position
on a level surface.
4. Remove the engine oil fill cap/dipstick (4)
from the left crankcase cover.
Checking & Adding Oil
(1) engine oil fill cap/dipstick
(2) upper level mark
(3) lower level mark
(1)
(2)
(3)
(1) engine oil fill cap/dipstick
(4) O-ring
(1)
(4)
Changing Engine Oil & Filter
(1) engine guard A bolts/washers
(2) engine guard B bolt/washer
(3) engine guard
(1)
(3)
(2)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honda CRF450L 2019 and is the answer not in the manual?

Honda CRF450L 2019 Specifications

General IconGeneral
Engine Type449cc liquid-cooled single-cylinder four-stroke
Bore x Stroke96.0mm x 62.1mm
Compression Ratio12.0:1
Fuel SystemProgrammed Fuel Injection (PGM-FI), 46mm throttle body
Transmission6-speed
Rear BrakeSingle 240mm disc
Front Tire80/100-21
Rear Tire120/80-18
Rake (Caster Angle)28.5°
Wheelbase58.9 inches
Seat Height37.1 inches
Fuel Capacity2.0 gallons
IgnitionFull transistorized ignition
Ground Clearance12.4 inches
Front Suspension49mm inverted fork; 12.0 inches of travel
Rear SuspensionPro-Link Showa single shock, adjustable spring preload, compression and rebound damping
Front BrakeSingle 260mm disc
Curb Weight289 pounds
Valve TrainUnicam four-valve
Final DriveChain
Trail4.6 inches (118mm)

Related product manuals